Most put spread questions are about where to put the strikes. A question that matters at least as much is how many contracts to sell. This article shows a simple way to answer it: start from the maximum loss of the trade and decide how much of your account you accept to lose on it. The numbers are invented and are not a recommendation.

Step 1: the maximum loss of one contract

For a put spread the maximum loss is known in advance: (width of the spread − credit received) × 100. For a $5-wide spread sold for a $0.80 credit it is ($5.00 − $0.80) × 100 = $420 per contract. The basics are in the bull put spread explained.

Step 2: decide the loss you accept on one trade

Pick a share of your account that you can lose on a single trade without it hurting your plans. Many traders use a small figure such as 1–2%. With an account of $25,000, 2% is $500.

Free one-page checklist (read the signal, check the trend filter, size by maximum loss, place the order and set the exits), plus the 20-page SPY Put Spread Playbook (PDF) in your welcome email.

No spam. Unsubscribe anytime.

Step 3: divide

$500 ÷ $420 = 1.19, so you round down to 1 contract. Two contracts would put $840 at risk, which is 3.4% of the account. If the rounding leaves you at zero, the trade is too big for your account: use a narrower spread or skip it.

Account2% limitContracts ($420 max loss each)
$10,000$2000 (too big)
$25,000$5001
$50,000$1,0002

Step 4: add up the positions open at the same time

The most common mistake is to size each trade alone. Put spreads opened in the same weeks tend to lose together, because they depend on the same market. Three positions open at once with $420 each means $1,260 at risk, which is 5.0% of a $25,000 account. Decide a limit for the total maximum loss as well, and count every position that could be open at the same time. Our own review of stops and overlapping trades is in the best credit spread strategy.

A fixed size is not a sizing rule

The FIREDesk paper record uses a fixed 4 contracts on $10-wide spreads, so it shows how the signals behaved, not how to size them for an account. Your size should come from your account and your limit, not from ours. The full record is on the performance page.

Checklist

  • Maximum loss per contract: (width − credit) × 100.
  • Loss you accept on one trade, in dollars.
  • Round the number of contracts down, never up.
  • Add up the maximum loss of every position open at once and compare it with a total limit.
  • If you would have to size to zero contracts, the trade does not fit your account.

Educational content, not financial advice. Options trading involves significant risk of loss, including the loss of the whole amount at risk on a trade. All figures are made-up examples, and past and simulated results do not guarantee future performance.

Frequently Asked Questions

How many put spread contracts should I sell? +

Divide the loss you accept on one trade by the maximum loss of one contract, (width minus credit) times 100, and round down. Then check that the total maximum loss of all positions open together stays within a limit you set.

Is risking 2% per trade the right size? +

There is no single right figure. 1 to 2% is a common starting point, but the right limit depends on your account, your plan and how many positions you hold at once.

Why add up positions open at the same time? +

Put spreads on the same market tend to lose at the same time. Sizing each one alone can leave the total risk much higher than you intended.